Application performance of Henkel Loctite Frekote release agent

Lotte Frekote mold release agent can be used for all natural or synthetic rubber molding including silicone rubber. Frekote has high temperature stability so it can guarantee multiple releases. It enables customers to achieve higher production efficiency and thus higher profits, because the use of Frekote can reduce the residence time and improve product quality. Other advantages of Frekote are: 1. Reduce mold pollution; 2. Reduce scrap rate; 3. Reduce the impact on rubber and rubber bonding; 4. Reduce the impact on rubber and metal bonding.

Loctite AC4368 low-odor industrial release agent

Lotte AC4368 release agent product advantages: high brightness, no pollution transfer, room temperature curing. Construction temperature: 13°C-135°C; Application: epoxy, unsaturated polyester, vinyl resin, rotating resin.

Loctite 770-nc epoxy resin release agent

Loctite 770nc release agent product specifications: 3.78L; product color: colorless; specific gravity: 0.720+/-0.015; temperature resistance: 400°C; application: release application; solvent: butyl ether.

Loctite 55-nc FRP mold release agent

Loctite 55-nc mold adhesive product specifications: 3.78L; product color: colorless; flash point: -7°C; temperature resistance: 400°C; application: demolding application; solvent: butyl ether.

Loctite HMT-2 rubber release agent

Loctite HMT-2 mold release agent is used in a variety of film agents to minimize the failure rate and will not cause pollution transfer. This product is an excellent solvent-based release product that can be used for a variety of release applications on hot molds with temperatures above 50 degrees Celsius. With a lower moisture sensitivity, brush or spray 4-5 layers of wet film coating on a clean mold surface. It takes 10 minutes to wait for the product to evaporate within the solvent evaporation time. The product has achieved curing. Start casting immediately.